Mitsubishi Electric MELSERVO-J2S Series Transition Handbook page 9

Dealing with overseas standards
Refer to the following relevant manuals concerning dealing with overseas standards.
«About the manual»
This Replacement Manual and the following Instruction Manuals are necessary when using this servo for
the first time. Ensure to prepare them to use the servo safely.
Relevant manuals
MELSERVO-J4 Series Instructions and Cautions for Safe Use of AC Servos
(Packed with the servo amplifier)
MELSERVO-J4 Servo Amplifier Instruction Manual (Troubleshooting Edition)
MELSERVO Servo Motor Instruction Manual (Vol. 3) (Note 1)
MELSERVO Linear Servo Motor Instruction Manual (Note 2)
MELSERVO Direct Drive Motor Instruction Manual (Note 3)
MELSERVO Linear Encoder Instruction Manual (Note 2, 4)
EMC Installation Guidelines
Note 1. It is necessary for using a rotary servo motor.
2. It is necessary for using a linear servo motor.
3. It is necessary for using a direct drive motor.
4. It is necessary for using a fully closed loop system.
«Cables used for wiring»
The wiring cables mentioned in this Replacement Manual are selected based on an ambient temperature
of 40 °C.
«U.S. customary units»
U.S. customary units are not shown in this manual. Convert the values if necessary according to the
following table.
Mass
Length
Torque
Moment of inertia
Load (thrust load/axial load)
Temperature
«Display»
The following abbreviations are used for the model names of the servo amplifiers in this Replacement
Manual.
[J2S-A]: MR-J2S-_A_
[J2S-B]: MR-J2S-_B_
[J2S-CP]: MR-J2S-_CP_
[J2S-CL]: MR-J2S-_CL_
[J2M-A]: MR-J2M-_A
[J2M-B]: MR-J2M-_B
[J4-A]: MR-J4-_A_
[J4-B]: MR-J4-_B_
Parameter No._ _: [Pr. _ _ ]
Manual name
Quantity
1 [kg]
1 [mm]
1 [N•m]
1 [(× 10
1 [N]
N [°C] × 9/5 + 32
SI (metric) unit
-4 kg•m 2 )]
A - 8
Manual number
IB(NA)0300175
SH(NA)030108
SH(NA)030099
SH(NA)030095
SH(NA)030097
SH(NA)030096
IB(NA)67303
U.S. customary unit
2.2046 [lb]
0.03937 [inch]
141.6 [oz•inch]
5.4675 [oz•inch 2 ]
0.2248 [lbf]
N [°F]