Mitsubishi Electric MELSERVO-J2S Series Transition Handbook page 178

Part 5: Review on Replacement of MR-J2S-30 kW or Higher Capacity Models with MR-J4-DU_
(3) MR-J4-DU_B_
(a) Power-on procedure
1) For the power supply wiring, make sure to use a magnetic contactor (L1/L2/L3) in the main circuit
power supply as shown in Section 2.1.
Configure the circuit so that the magnetic contactor is turned off at the same time as an alarm is
generated in the external sequence.
2) Turn on the control circuit power supply (L11/L12) of the converter unit and that of the drive unit
at the same time as or before turning on the main circuit power supply. If the main circuit power
supply is not turned on, a warning is displayed on the drive unit display. However, the warning
disappears and operation returns to normal when the main circuit power supply is turned on.
(b) Timing chart
1) If the magnetic contactor driving output is enabled and the ready-on is on, turning SON off does
not shut off the main circuit power supply.
Servo motor
speed
Drive unit
control circuit
power supply
Converter unit
control circuit
power supply
Main circuit
power supply
Base circuit
MBR
(Electromagnetic
brake interlock)
Servo-on command
(from servo system
controller)
Position command
(Note 3)
Note 1. When setting up an electromagnetic brake at customer's side, make up a sequence which will operate the
electromagnetic brake as follow using MBR (Electromagnetic brake interlock).
ON: Electromagnetic brake is not activated.
OFF: Electromagnetic brake is activated.
2. Give a position command after the external electromagnetic brake is released.
3. This is in position control mode.
4. In [Pr. PC02 Electromagnetic brake sequence output], set a delay time (Tb) from MBR (Electromagnetic brake
interlock) off to base circuit shut-off at a servo-off.
0 r/min
ON
OFF
ON
OFF
ON
OFF
(3 s)
ON
OFF
(Note 1) ON
OFF
ON
OFF
0 r/min
(Note 2)
5 - 17
(Note 4)
Tb
(95 ms)