Connecting The Asi Outputs And The Asi Monitor - Cisco D9054 Installation And Operation Manual

Connecting the ASI Outputs and the ASI Monitor

To Connect the ASI Outputs
Do as follows to connect to the ASI output:
1. Connect the output signals from the D9054 HD Encoder connectors ASI OUT 1
and/or ASI OUT2 to the ASI input connectors of the equipment after the D9054
HD Encoder.
Use a Belden "Brilliance" (or equivalent) cable with foil/braid construction. The
shield must provide 99% or better shielding effectiveness (i.e. high-quality
double-shielded RJ6 coaxial cable).
The equipment after the D9054 HD Encoder could be a Transport Stream
Multiplexer such as the Continuum DVP D9600 Re-multiplexer and Transport
Stream Processor.
Hint: The two outputs are identical and can be used for back-up purposes.
2. If you want to check the ASI output signal connect an ASI monitor to the ASI
monitor connector.
Note: The ASI monitor output cannot be muted but otherwise it works similar
to the two primary outputs.
4038938 Rev A D9054 HDTV Encoder Intstallation and Operation Guide 3-13