Cisco D9054 Installation And Operation Manual page 28

Front Panel Setup,
6. Press the UP arrow to leave the IP menu.
Note: When you leave the IP menu by pressing the UP Arrow key the IP, Mask
and Gateway parameters are validated against each other and stored. Any
inconsistencies will be shown in the display.
Important: For the changes to take effect you must reset the D9054 HD Encoder
after you have finished setting or changing the IP address, subnet mask and
default gateway. Proceed as follows to reset the D9054 HD Encoder.
7. From the main menu press the RIGHT arrow to navigate to the System menu,
and then press the SELECT key.
8. Press the Right arrow to navigate to Reset and then press the SELECT key.
9. When are prompted to confirm that you want to reset the encoder, press the
SELECT key once more to confirm the reset. The encoder will reset.
1-4
Continued
D9054 HDTV Encoder Intstallation and Operation Guide 4038938 Rev A