Setting Up Statistical Multiplexing Quality Of Service - Cisco D9054 Installation And Operation Manual

Setting Up Statistical Multiplexing Quality of Service

To Set Up the Statistical Multiplexing Quality of Service
Proceed as follows to set up the Statistical Multiplexing Quality of Service:
1. From the user interface of the D9054 HD Encoder click the Video tab, expand
the H.264 icon, expand the Statistical Multiplexing icon and click the Quality
of Service icon from the sub-pages.
2. Choose the desired quality of service (QoS Mode); either Differentiated Service,
ToS/CoS (Precedence) or Custom. The default is ToS/CoS (Precedence). These
settings are used to guide the selection of the actual service parameters when
transmitting data through a network.
Each of the three available modes and the RFC (Request for Comment)
references to set these modes are described in the following table.
Differentiated Service
ToS/CoS (Precedence)
Custom
5-32
Mode
Refer to RFC 2474 and RFC 3260. Supports configuration of TOS bits in the
IP header, allowing integration in Diff Serve networks.
Type of service precedence. Refer to RFC 791.
Refer to RFC 3168.
D9054 HDTV Encoder Intstallation and Operation Guide
Description
4038938 Rev A