Cisco D9054 Installation And Operation Manual page 236

Message Description and Remedy
H264 IP Statmux: Description: The mainboard host
DSP End of frame processor (PPC) has lost control of the
sync error communication buffers.
Remedy: If the error is not resolved
immediately, power-cycle the encoder. If
this does not correct the issue, contact the
closest Cisco customer support center for
assistance.
H264 IP Statmux: Description: A statmux message failed to
Network arrive when expected. Causes may
communication include network jitter or encoders not
error synchronized. Either blackburst sources
to the encoders or video sources to
encoders are not in sync depending on
which method is being used.
H264 IP Statmux: Description: The encoder was not
QP Threshold assigned enough bits by the statmux
error algorithm and is encoding at a low
quality. This can occur if the group rate is
too low for the content (i.e., low group bit
rate and very difficult content on all
channels at the same time.)
H264 IP Statmux: Description: The mainboard host
PPC beginning of processor (PPC) has lost control of the
frame sync error communication buffers.
Remedy: If the error is not resolved
immediately, power-cycle the encoder. If
this does not correct the issue, contact the
closest Cisco customer support center for
assistance.
H264 IP Statmux: Description: The mainboard host
PPC End of frame processor (PPC) has lost control of the
sync error communication buffers.
Remedy: If the error is not resolved
immediately, power-cycle the encoder. If
this does not correct the issue, contact the
closest Cisco customer support center for
assistance.
6-14 D9054 HDTV Encoder Intstallation and Operation Guide
Severity Default
Alarm
Category
Major B
Major A
Minor B
Major B
Minor B
4038938 Rev A
Enable
On
On
On
On
On