Setting Up The Layer Ii Audio Program - Cisco D9054 Installation And Operation Manual

Setting Up the Layer II Audio Program

To Set Up the Layer II Audio Program
Proceed as follows to set up the Layer II Audio Program:
1. From the user interface of the D9054 HD Encoder, click the PSI tab, expand
Audio and then the Layer II icon and click one of the channel icons from the
sub-pages.
Note: The number of channels displayed depends on whether your encoder is
equipped with a Dual Channel Audio (DCA) card or a Multiple Channel Audio
(MCA) card. MCA cards provide six configurable audio channels, allowing you
to configure Ch 1+2 (Audio 1) through Ch 11+12 (Audio 6).
2. If relevant, select Enable PCR to enable the PCR.
Important: An audio only program consisting of one or more audio tributaries
must have at least one PCR PID enabled. If the audio is attached to the Video it
does not need a PCR PID as long as the stream carries a PCR PID.
3. Type the audio PID.
The legal range is from 16 to 8190
for any other program element.
4. Type the audio Language.
You must type in three letters. The supported languages are according to ISO
639-2. The audio language is signalled in a PSI table and used by satellite
receivers. See ISO 639-2 Language Codes, page C-1 for more information.
1) Note that the DVB tables use the PIDs from 16 to 20.
4038938 Rev A D9054 HDTV Encoder Intstallation and Operation Guide
1)
. Observe that you may not use the same PID
5-107