Output Menu - Cisco D9054 Installation And Operation Manual

Output Menu

Structure
To see the Output menu from the Main menu press the RIGHT Arrow key three
times and the SELECT key.
Each parameter is described below. The menu has the following structure:
Output Bit Rate
Parameters:
Steps:
Description:
ASI Mode
Parameters:
Description:
Output Format
Parameters:
Description:
4) 204 bytes mode is not applicable to the PNC Control System.
4-22
10M to 120M.
1 bit/s.
The ASI output bit rate (transport stream rate). For information
about how much the various tributaries (video, audio etc.) take up
of in the transport stream, see Transport Stream Rates for the
Tributaries, page B-3.
Packet, Burst.
In Packet mode you send a whole MPEG packet together (188/204
bytes) and have stuffing in between packets. In Burst mode you
send 1 byte at a time with stuffing in between. Some non-Cisco
decoders specifically require Packet or Burst mode.
188, 204 RS Off.
188 means that the Reed Solomon Error Correction algorithm is not
applied on the IP TS output.
204 RS OFF. This setting only applies in a stand-alone or ROSA
controlled application. The setting means that the Reed Solomon
algorithm is not applied on the output. The 16 bytes overhead are 0
bytes which may later be used for Reed Solomon error correction.
D9054 HDTV Encoder Intstallation and Operation Guide
4)
4038938 Rev A