Cisco D9054 Installation And Operation Manual page 235

Message Description and Remedy
H264 IP Statmux: Description: A statmux message did not
Group rate arrive at the encoder. This may occur if
message missing the statmux network drops packets or the
Ethernet port fails.
H264 IP Statmux: Description: Statmux messages arrived at
Unexpected an encoder that is not in the group.
group rate
message
H264 IP Statmux: Description: Multiple statmux messages
Multiple group arrive at the encoder in 1 s-tick with the
rate messages same encoder Id. This is usually caused
by multiple encoders having the same
value for the last byte of their statmux
port Ethernet address.
Remedy: Ensure that the encoders all
have a different value for the last byte of
the Ethernet address.
H264 IP Statmux: Description: This occurs when trying to
Group rate mode mix encoders that have different control
mismatch types set (i.e., Standalone, redundancy
controller, DCM, DCM no redundancy).
Remedy: Set all encoders to the same
controller type.
H264 IP Statmux: Description: There is confusion between
Not in group rate the encoders about which encoders are in
message bitmask the group. This can occur if certain
statmux messages are dropped by the
network.
H264 IP Statmux: Description: The mainboard host
DSP Beginning of processor (PPC) has lost control of the
frame sync error communication buffers.
Remedy: If the error is not resolved
immediately, power-cycle the encoder. If
this does not correct the issue, contact the
closest Cisco customer support center for
assistance.
4038938 Rev A D9054 HDTV Encoder Intstallation and Operation Guide
Severity Default
Alarm
Category
Major A
Minor B
Major A
Major A
Major A
Major B
Enable
On
On
On
On
On
On
6-13