Cisco D9054 Installation And Operation Manual page 184

Setting Up the IP Streaming Output,
12. Enter the Output Bitrate for each IP stream in the range from 50,000 to
120000000 bit/s (120 Mb/s).
Important: Maintain TS Rate must be enabled for each active IP stream;
otherwise the corresponding Output Bitrate setting will have no affect on the TS
output. The default is 12500000 (12.5 Mb/s).
13. Enable Maintain TS Rate for each active IP stream. This parameter is used to
indicate whether or not to transmit ASI null packets in the associated IP stream.
If enabled, the IP payload bit rate will controlled by the Output Bitrate setting. If
disabled, no ASI NULL packets are transmitted in the associated IP stream. The
default is enabled (checked).
14. Enable Transparent mode for each active IP stream. When the mode is enabled,
all PIDs/services transmitted on the ASI output will also be transmitted in the
associated IP stream. In other words, the IP stream service selection page is
ignored. The default is disabled (unchecked). (Null packets are selected using
the Maintain TS Rate parameter above).
Note: Auto Ping and Auto Ping Timeout are only used when troubleshooting
the IP connection to the receiver. Auto Ping allows you to transmit ping packets
to the destination address specified for the selected device(s). When Auto Ping is
enabled (On), ping packets are transmitted every 20 seconds. If no valid reply is
received within the specified timeout period, an alarm is issued to the
management system. The Auto Ping default is Off.
15. Set the Auto Ping Timeout to a value in the range from 1000 to 10000 (in ms).
The default is 5000 ms.
16. The D9054 HD Encoder can stream up to eight services on one IP output.
Proceed as follows to set up each of up to eight services for each stream. From
the user interface of the D9054 HD Encoder click the TS Output tab and the IP
Service Selection icon from the sub-pages.
5-100 D9054 HDTV Encoder Intstallation and Operation Guide
Continued
4038938 Rev A