System Menu - Cisco D9054 Installation And Operation Manual

System Menu

Structure
To see the System menu from the Main menu press the RIGHT Arrow key four
times and the SELECT key.
Each parameter is described in the following. For instructions on how to select and
store settings, see About the Front Panel, page 4-2.
The menu has the following structure:
Status IP Reset
Alarms
Alarms
[A][3]LayerII: Digital Input loss
Alarms
No Alarms
Status, Alarms
Parameters:
Description:
IP, IP Address
Parameters:
Description:
4-24
System
Default > < Software Version
Status
Main
Reset Login
IP Address
N/A.
A list of alarms in the system. The most recent ones are displayed
first.
<0 to 255>.<0 to 255>.<0 to 255>.<0 to 255>.
The IP address of the management interface to the D9054 HD
Encoder. Contact your network administrator to obtain an IP
address.
Use the numeric keys to type the IP address.
Press the SELECT key to store the entered values.
Press the UP Arrow key to leave the menu.
When you leave the IP menu by pressing the UP Arrow once more
the IP, Mask and Gateway parameters are validated against each
other and stored. Any inconsistencies will be shown in the display.
Important: For the changes to take effect you must reset the encoder
after you have finished setting or changing the IP address, subnet
mask and default gateway. The encoder will display a reminder.
Note: The reset may take up to 90 seconds.
Note: The IP Address is not affected by the Default command.
D9054 HDTV Encoder Intstallation and Operation Guide
System
Module Info >
Module Info
Audio1 Audio2
HTTP
IP
Mask Gateway Speed/Duplex
System
< Option License HTTP
Option License
PNC Dolby Digital DPI PIP/H.264
Dolby Digital
Ch1 Ch2
Option License
< AAC Statmux High Profile
Option License
< Dolby Digital Plus Dolby-E Decoder
4038938 Rev A
>
>