Reading the System Information or Managing the System
To Read the System Information or to Manage the System
Proceed as follows to read the system information or to manage the System:
1. From the user interface of the D9054 HD Encoder, click the System tab.
The GUI automatically displays the serial number, software version, operating
hours, the version of the boot code and the D9054 device driver/GUI version.
Important: Have the above information readily available if you contact a Cisco
office for support.
2. If relevant, enable Lock Front Panel to lock the front panel.
When the front panel is locked you can only see settings but not change them
from the front panel menus.
3. If relevant, click Default to default all settings in the D9054 HD Encoder.
Hint: Use the default settings if you have set up the D9054 HD Encoder with
illegal and incompatible settings to get the encoder back in a functional state.
4. If relevant, click Reset to reset (boot) the D9054 HD Encoder.
Hint: You should reset the D9054 HD Encoder if you have set or changed the IP
address of the encoder via the front panel display.
5-120
Section H - Working with the System
D9054 HDTV Encoder Intstallation and Operation Guide
4038938 Rev A