Cisco D9054 Installation And Operation Manual page 69

Audio Menu,
Continued
Layer II, <ch1 to ch12>, Mode
Parameters:
Description:
Important: If you select the Single Mono mode, you get the setup which has been
enabled in the ROSA GUI.
Layer II, <ch1 to ch12>, Audio PID
Parameters:
Description
Dolby Digital, <ch1 to ch6>
Parameters:
Description:
Dolby Digital, <ch1 to ch6>, Control
Parameters:
Description:
Dolby Digital, <ch1 to ch6>, Input
Parameters:
Description:
1) Note that the DVB tables use the PIDs from 16 to 20.
4038938 Rev A
Stereo, Joint Stereo, Dual Channel, Single Mono.
Do not use Joint stereo audio coding if you want to transfer
matrixed sound (i.e., Dolby Surround). Use Stereo instead. If you
use Joint stereo, part of the phase information which is essential for
re-creating the surround channel information disappears.
A figure between 16 to 8190
Observe that you may not use the same PID for any other program
element.
Ch1 to Ch6.
Select the channel you want to set up.
Note: The number of channels displayed depends on whether your
encoder is equipped with a Dual Channel Audio (DCA) card or a
Multiple Channel Audio (MCA) card. MCA cards provide six
configurable audio channels, allowing you to configure Ch 1
through Ch 6.
Enable, Disable.
Enable or disable the channel in question.
Digital, Embedded, Dolby-E Decoder.
The D9054 HD Encoder inputs the signal from the Digital input
connector in the selected format. If you select Embedded the D9054
HD Encoder extracts the audio embedded in the active SDI video
signal of the program. The packet and pair is set in the GUI.
Note: Dolby-E Decoder input type is only available if the D9054
Encoder has a Multiple Channel Audio (MCA) card that is
equipped with a Dolby Advanced Sub-Module (DASM).
D9054 HDTV Encoder Intstallation and Operation Guide
1)
.
4-15