Cisco D9054 Installation And Operation Manual page 72

Audio Menu,
Continued
Dolby Digital, <ch1 to ch6>, Audio PID
Parameters:
Description
Linear/Dolby E, <ch1 to ch6>
Parameters:
Description:
Linear/Dolby E, <ch1 to ch6>, Control
Parameters:
Description:
Linear/Dolby E, <ch1 to ch6>, Input
Parameters:
Description:
Linear/Dolby E, <ch1 to ch6>, Mode
Parameters:
Description:
Linear/Dolby E, <ch1 to ch6>, Audio PID
Parameters:
Description
2) Note that the DVB tables use the PIDs from 16 to 20.
4-18
A figure between 16 to 8190
Observe that you may not use the same PID for any other program
element.
Ch1 to Ch6.
Select the channel you want to set up.
Note: The number of channels displayed depends on whether your
encoder is equipped with a Dual Channel Audio (DCA) card or a
Multiple Channel Audio (MCA) card. MCA cards provide six
configurable audio channels, allowing you to configure Ch 1
through Ch 6.
Enable, Disable.
Enable or disable the selected channel.
Digital, Embedded.
The D9054 HDTV Encoder inputs the signal from the Analog/
Digital input connector in the selected format. If you select
Embedded, the D9054 HDTV Encoder extracts the audio embedded
in the active SDI video signal of the program. The packet and pair is
set in the GUI.
Linear or Dolby E.
Use this setting to select between Linear and Dolby E mode.
A figure between 16 to 8190.
Observe that you may not use the same PID for any other program
element.
D9054 HDTV Encoder Intstallation and Operation Guide
2)
.
4038938 Rev A