Setting Up The Aac Test Tones - Cisco D9054 Installation And Operation Manual

Setting Up the AAC Test Tones

To Set Up the AAC Test Tones
Proceed as follows to set up the AAC Test Tones:
1. From the user interface of the D9054 HD Encoder, click the Audio tab, expand
the AAC icon, expand the appropriate channel icon and click the Test Tones
icon from the sub-pages.
Note: The number of channels displayed depends on whether your encoder is
equipped with a Dual Channel Audio (DCA) card or a Multiple Channel Audio
(MCA) card. MCA cards provide six configurable audio channels, allowing you
to configure Ch 1 (Audio 1) through Ch 6 (Audio 6).
2. If relevant, set and enable the left and/or right test tones.
Note: When Test Tones Left or Test Tones Right are set to Off, the respective
channel encodes the incoming signal.
5-78 D9054 HDTV Encoder Intstallation and Operation Guide 4038938 Rev A