Setting Up The Ip Network - Cisco D9054 Installation And Operation Manual

Setting Up the IP Network

The D9054 HD Encoder can transmit the IP output to an IP network device with a
predefined MAC address and IP address on a selected IP subnet.
Setup in the D9054 HD Encoder ROSA/Web Interface
To Set up the Management and IP Ports
Before you can communicate with third party management devices or stream video
to a set top box, you need to set up the IP parameters of the D9054 Encoder data
Management and Ethernet ports.
Do as follows to set the communication parameters of these ports:
1. From the user interface of the D9054 HD Encoder click the System tab and the
IP Network icon from the sub-pages.
ROSA automatically displays a list of available options and their status.
2. Enter the IP Address for the Management interface/port and two IP ports. This
is the IP address of the IP port. Check with your network administrator for the
IP address to assign to this port.
Note: If you change the IP Address for the Management interface/port, the
encoder will automatically reset.
3. Enter the Subnet Mask for the Management interface/port and two IP ports.
These fields are set to a default value commonly used by most networks. If the
Subnet Mask for your network is different than that displayed in this field,
contact your Network Administrator and enter it in this field. The default is
255.255.255.000.
4. Enter the Default Gateway for your network to enable transmission of IP data
off of the subnet. Contact your Network Administrator for your Gateway
address.
5. Select the Speed/Duplex for the Management interface/port and two IP ports.
The default is Auto Negotiation.
4038938 Rev A D9054 HDTV Encoder Intstallation and Operation Guide 5-137