Setting Up The Message Parameters - Cisco D9054 Installation And Operation Manual

Setting Up the Message Parameters

To Set Up the Message Parameters
Proceed as follows to set up the message parameters:
1. From the user interface of the D9054 HD Encoder, click the System tab and the
Message Settings icon from the sub-pages.
The Message Settings table displays a list of all available Messages in the D9054
HD Encoder system.
2. For each of the messages, select Enable if you want the message to be enabled.
If you enable a message it means that a message is sent to the ROSA element
manager whenever the message event occurs.
Note: De-selecting the Enable box will not disable reporting of the message in
the Message Status and Message Log.
Important: You will not be able to see any messages in the ROSA GUI until you
have set up the trap destination for the messages. For further information
Setting Up the Trap Destinations, page 5-128.
5-124 D9054 HDTV Encoder Intstallation and Operation Guide 4038938 Rev A