Setting Up The Layer Ii Channel Information - Cisco D9054 Installation And Operation Manual

Setting Up the Layer II Channel Information

To Set Up the Layer II Channel Information
Proceed as follows to set up the Layer II Channel Information:
1. From the Layer II sub-pages, expand the relevant channel icon and click the left
or right channel icon.
Important: The left channel applies to all encoding modes whereas the right
channel only applies to Single Mono Right.
2. Select On or Off to enable or disable Emphasis.
Emphasis is normally set to Off.
3. Select Copyright if you want to signal that the encoded bit stream is protected
by copyright. The default is selected.
4. Select Original if you want to signal that the encoded bit stream is an original.
The default is selected.
5. Click Apply.
5-50 D9054 HDTV Encoder Intstallation and Operation Guide 4038938 Rev A