Setting Up The Trap Destinations - Cisco D9054 Installation And Operation Manual

Setting Up the Trap Destinations

Important
If you have a firewall between the D9054 HD Encoder and the Copernicus/Trap
server you may need to change the protection settings to allow the SNMP traps
from the D9054 HD Encoder (UDP packets) to arrive to the Copernicus/Trap
server. To enable the D9054 HD Encoder Alarm/Message mechanism in ROSA you
must add a trap destination IP address to which the D9054 HD Encoder will start
sending its SNMP traps
To Set Up the Trap Destination
Proceed as follows to set up the trap destination:
1. From the user interface of the D9054 HD Encoder, click the System tab and the
Trap Destination icon from the sub-pages.
2. Click Add Row.
1) With ROSA you can define up to 10 trap destinations. With the web interface you can set
up one trap destination.
5-128
1)
.
D9054 HDTV Encoder Intstallation and Operation Guide 4038938 Rev A