Setting Up the Linear Parameters
To Set Up the Linear Parameters
Proceed as follows to set up the linear parameters:
1. From the user interface of the D9054 Encoder click the Audio tab, expand the
Linear/Dolby-E icon, expand the appropriate channel icon and click the Linear
icon from the sub-pages.
2. If relevant, enable the Sample Rate Converter.
Enable the sample rate converter if your source is not synchronized to the D9054
Encoder.
3. Set the Bit Depth.
The sample rate is 48 kHz. You may select 16, 20 or 24 bits.
Note: The bit depth setting is only applicable for linear mode. The bit depth is
always 20 bits in the Dolby-E mode.
4. Click Apply.
4038938 Rev A
D9054 HDTV Encoder Intstallation and Operation Guide
5-83