Setting Up The Statistical Multiplexing Redundancy - Cisco D9054 Installation And Operation Manual

Setting Up the Statistical Multiplexing Redundancy

To Set Up the Statistical Multiplexing Redundancy
Proceed as follows to set up the Statistical Multiplexing Redundancy:
1. From the user interface of the D9054 HD Encoder click the Video tab, expand
the H.264 icon, expand the Statistical Multiplexing icon and click the
Redundancy icon from the sub-pages.
2. Set the Role of the D9054 Encoder. The encoder's role is normally set as Primary,
but may be set to Secondary for use as a backup encoder.
3. Set the operating State of the Secondary encoder to either Active or Standby.
Active means the encoder is fully participating in the statmux pool. Standby
means the encoder does not participate in the statmux pool.
4. Click Apply.
5-34 D9054 HDTV Encoder Intstallation and Operation Guide 4038938 Rev A