Setting Up The Linear/Dolby E Processing - Cisco D9054 Installation And Operation Manual

Setting Up the Linear/Dolby E Processing

To Set Up the Linear Processing
Proceed as follows to set up the Linear/Dolby-E Processing:
1. From the user interface of the D9054 Encoder click the Audio tab, expand the
Linear/Dolby-E icon, expand the appropriate channel icon and click the
Processing icon from the sub-pages.
Note: The number of channels displayed depends on whether your encoder is
equipped with a Dual Channel Audio (DCA) card or a Multiple Channel Audio
(MCA) card (MCA). MCA cards provide six configurable audio channels,
allowing you to configure Ch 1 (Audio 1) through Ch 6 (Audio 6).
2. Select Copyright if you want to signal that the encoded bit stream is protected
by copyright. The copyright has the same meaning as the copyright bit on CDs
and DAT tapes, i.e. telling that it is illegal to copy the contents if the bit is set.
The default is selected.
3. Select Original if you want to signal that the encoded bit stream is located on its
original media. The default is selected.
4. Click Apply.
5-82 D9054 HDTV Encoder Intstallation and Operation Guide 4038938 Rev A