Connecting The Ip Ts Outputs - Cisco D9054 Installation And Operation Manual

Connecting the IP TS Outputs

The Ethernet Interface
The RJ-45 interfaces IP TS OUT 1 and IP TS OUT 2 are 10/100 BASE-T Ethernet.
They are intended for output of the transport stream encapsulated in IP packets to
the main receiver.
Pin Allocation, Ethernet Connector
The table shows the Ethernet connector and the pin allocation (MDI interface)
Connector
1
Informative Notes
For reliable Ethernet operation; to run over a maximum segment length of 100 m
the cable has to comply with the EIA/TIA Category 5 wire specifications. The cable
must be shielded to ensure compliance with EMC requirements.
To Connect the Ethernet Interface
1. Connect a crossed RJ-45 cable between the Ethernet connector on the D9054 HD
Encoder and the Ethernet port of the equipment after the D9054 HDTV Encoder.
Note: You need a crossover cable if you want to connect the Ethernet interface of
the D9054 HD Encoder directly to another Ethernet device without using a hub or
switch.
The equipment after the D9054 HDTV Encoder could be an IP router or a switch.
3-12
Pin
1 Tx+
2 Tx-
3 Rx+
4 Not connected
5 Not connected
8
6 Rx-
00-052
7 Not connected
8 Not connected
D9054 HDTV Encoder Intstallation and Operation Guide
Pin Allocation
:
4038938 Rev A