Setting Up The Video Program - Cisco D9054 Installation And Operation Manual

Setting Up the Video Program

To Set Up the Video Program
Proceed as follows to set up the Video Program:
1. From the user interface of the D9054 HD Encoder, click the PSI tab and the
Video icon from the sub-pages.
2. Enter the PID for the Video channel.
You may type a number in the range from 16 to 8190. Observe that you may not
use the same PID for any other program.
3. If relevant, select Enable PCR for the Video channel to enable the PCR for the
video channel and enter the Interval to send the PCR, in ms.
4. Enter the PID for the PIP channel.
You may type a number in the range from 16 to 8190
not use the same PID for any other program.
5. If relevant, select Enable PCR for the PIP channel to enable the PCR for the PIP
channel.
6. Click Apply.
1)Note that the DVB tables use the PIDs from 16 to 20.
5-106 D9054 HDTV Encoder Intstallation and Operation Guide
1)
. Observe that you may
4038938 Rev A