Cisco D9054 Installation And Operation Manual page 231

Message Description and Remedy
Description: The encoding rate is too high
Dolby Digital: TS
compared to the TS rate or the encoding
rate/Audio rate
rate is too low. The encoding will restart.
mismatch
Remedy: Check the settings. Change the
encoding rate or increase the TS rate. If a
FIFO occurs recurrently, contact the
closest Cisco customer support center for
assistance.
Description: It is not possible to
Dolby Digital:
implement the requested audio delay.
Audio delay error
Remedy: Decrease the audio data rate or
change the video settings to decrease the
end-to-end delay. Check the relative and
external delay settings.
Description: The audio delay setup on the
Dolby Digital:
Audio DSP is too low.
Requested audio
encoding delay Remedy: Increase the audio delay.
set too low
Description: The audio delay setup on the
Dolby Digital:
Audio DSP is too high. Remedy: Decrease
Requested audio
the audio delay.
encoding delay
set too high
Description: The requested PCR rate can
Dolby Digital:
not be achieved.
PCR insertion
rate not Remedy: No action possible.
achievable
Description: The incoming bit rate on
Dolby Digital:
passthrough is lower than the encoder
Passthrough
setting.
input rate lower
than requested Remedy: No action required.
output rate
Description: The incoming bit rate on
Dolby Digital:
passthrough is higher than the encoder
Passthrough
setting.
input rate higher
than requested Remedy: Increase the encoder setting to
output rate match the maximum incoming stream
rate.
4038938 Rev A D9054 HDTV Encoder Intstallation and Operation Guide
Severity Default
Alarm
Category
Minor B
Minor B
Minor B
Minor B
Minor B
Minor B
Minor B
Enable
On
On
On
On
On
On
On
6-9