Connecting to an Electrical Power Source
There are advanced setup options of the encoder that you will need to modify before running an encoder
Note
session. You will use the Niagara SCX® Web Interface to access these options. Refer to the User Guide
for Cisco Digital Media Encoder 1100 for detailed instructions.
Connecting to an Electrical Power Source
Figure 2
Figure 2
Using the reference chart and images in
the encoder.
Table 1
Connection
AC Power connector for 100-240
volts, AC, 50-60 Hz
Quick Start Guide for Cisco Digital Media Encoder 1100
2
shows the rear panel of the encoder.
Rear Panel
Rear Panel Power Connections
Table
1, you can connect the appropriate device and power to
Description
Plug the power cable that was include with your encoder to
this connector and plug the opposite end into an AC power
source or electrical wall outlet.
OL-17934-01