Cisco D9054 Installation And Operation Manual page 242

Message Description and Remedy
Linear/Dolby E: Description: Incoming packets were not
Passthrough PTS processed in time resulting in data being
error dropped.
Remedy: Check the expected maximum
passthrough rate and configure the audio
channel for the worst case input bit rate.
Description: The passthrough input
Linear/Dolby E:
header is incorrect.
Passthrough
header mismatch Remedy: Correct the passthrough input
header.
Description: Sample rate on passthrough
Linear/Dolby E:
input is incorrect.
Passthrough
sample rate Remedy: Correct the sample rate.
mismatch
Linear/Dolby E: Description: The incoming passthrough
Detected change rate has changed due to a change in the
in incoming audio program content.
passthrough rate
Remedy: Check whether changes in
audio content are expected. The message
serves as information only.
Linear/Dolby E: Description: The encoding rate is too high
TS rate/audio compared to the TS rate or the encoding
rate mismatch rate is too low. The encoding will restart.
Remedy: Check the settings. Change the
audio encoding rate or increase the TS
rate. If a FIFO error occurs recurrently,
contact the closest Cisco customer
support center for assistance.
Macro Close Description: An open macro has been
executed.
Remedy: None required.
Macro Open Description: A close macro has been
executed. Remedy: None required.
Power supply 1 Description: Power supply 1 has failed.
failure Remedy: Replace the power supply.
Power supply 2 Description: Power supply 2 has failed.
failure Remedy: Replace the power supply.
6-20 D9054 HDTV Encoder Intstallation and Operation Guide
Severity Default
Alarm
Category
Minor B
Major B
Major B
Minor B
Major B
Information None
Information None
Major B
Major B
4038938 Rev A
Enable
On
On
On
On
On
On
On
On
On