Cisco D9054 Installation And Operation Manual page 213

Setting Up the Trap Destinations,
3. Enter an index number (ID).
This is just a serial number. You may enter a number in the range from 1 to 10,
as long as it does not conflict with an existing number.
4. Type the IP Address of the ROSA/Copernicus server/Trap server to receive the
SNMP traps.
5. Type "public" in the Community String field.
ROSA does not evaluate the Community String field. It may be used by other
systems for security handling.
6. Click Apply.
Hint: After you have created a trap destination you can edit the fields directly
by typing in the field in question.
7. If relevant, change the Row Status for the SNMP trap.
The row status indicates whether the receiving unit is active or not in service.
Note: D9054 HD Encoder will not begin to send traps to the destination until
you set the row status to Active and click Apply.
Hint: Open Copernicus Server Explorer tree and verify that the trap destination
work by right-clicking the unit you have just defined as the receiver of the traps
and selecting "All Messages". ROSA displays an informational message from
the unit telling you that its settings have been updated.
8. Repeat steps two to seven for any additional SNMP trap server.
9. Click Close.
You will not see the added trap destinations until you click Close.
4038938 Rev A
Continued
D9054 HDTV Encoder Intstallation and Operation Guide 5-129