Cisco D9054 Installation And Operation Manual page 185

Setting Up the IP Streaming Output,
17. Enable the PSI/SI Tables and the Service number (Service 1 to Service 8) in the
column for each of the services setup for each ID.
Note: The eight Service IDs (Service 1 through Service 8) on the Service
Selection page correspond to the same IDs on the Stream Setup page.
18. Click the Quality of Service icon from the sub-pages.
19. Select the desired quality of service (Qos); either Differentiated Service, ToS/
CoS (Precedence) or Custom. The default is ToS/CoS (Precedence). These
settings are used to guide the selection of the actual service parameters when
transmitting data through a network.
Each of the three available modes and the RFC (Request for Comment)
references to set these modes are described in the following table.
Differentiated Service
ToS/CoS (Precedence)
Custom
4038938 Rev A
Mode
Refer to RFC 2474 and RFC 3260. Supports configuration of TOS bits in the
IP header, allowing integration in Diff Serve networks.
Type of service precedence. Refer to RFC 791.
Refer to RFC 3168.
D9054 HDTV Encoder Intstallation and Operation Guide
Continued
Description
5-101