Ip Proxy-Arp; Clear Arp-Cache - Cisco Small Business 300 1.1 Series Administration Manual

IP Addressing Commands
78-20269-01 Command Line Interface Reference Guide
Console (config)# ip arp proxy disable
35.9

ip proxy-arp

Use the ip proxy-arp Interface Configuration mode command to enable an ARP
proxy on specific interfaces. Use the no form of this command disable it.
Syntax
ip proxy-arp
no ip proxy-arp
Default Configuration
ARP Proxy is disabled.
Command Mode
Interface Configuration (Ethernet, VLAN, Port-channel) mode. It cannot be
configured for a range of interfaces (range context).
User Guidelines
This configuration can be applied only if at least one IP address is defined on a
specific interface.To use this command, you must put the switch into routing mode
using the set system mode router command.
Example
The following example enables ARP proxy when the switch is in router mode.
Console(config-if)# ip proxy-arp

35.10 clear arp-cache

Use the clear arp-cache Privileged EXEC mode command to delete all dynamic
entries from the ARP cache.
Syntax
clear arp-cache
35
486