Honda CRF450R 2009 Service Manual page 423

FRONT WHEEUSUSPENSION/STEERING
Align the edges on the throttle pipe end with the tab and
-6"
mark of the right handlebar grip.
Align the tab on the left handlebar grip with the paint
marl<. on the handlebar.
RIGHT SIDE:
LEFT SIDE: TAB
EDGES
MARK PAINT MARK
Apply specified grease
(page 1-21) to the throttle cable
~~;;:;;;;:;~===ir;;;;:::::=;';;;;~~~~~
ends and throttle pipe flange groove.
Connect the throttle cables to the throttle pipe.
Tighten the throttle cable bolt to the specified torque.
TORQUE: 4.0 N-m (0.4 kgf-m , 3.0 IbHt)
Install the throttle housing, aligning the end of the
~==~~~~~~~~=======~
housing with the paint mark on the handlebar.
Tighten the throttle housing upper boll first, then the
lower bolt.
Adjust the throttle grip freeplay (page 4-8).
Inslall the brake master cylinder and holder with the
~M~A~S ~ T~E ~ R;====:;';:;:;;;=;:;;;~==~~~;l
"UP· mark on the holder facing up.
I
Align the end of the holder with the paint mark on the CYLINDER .....
_~~~
handlebar.
Install and tighten the upper master cylinder holder bolt
first. then the lower bolt to the specified torque.
TORQUE :9.9 N'm (1.0 kgf-m , 7.3 1bHtJ
"UP" MARK
TS
14-63