Honda CRF450R 2009 Service Manual page 374

FRONT WHEEUSUSPENSION/STEERING
RepJace the wheel
bearings in pairs.
Do
not
reuse old
bearings.
14-14
Place the rim on a woO< bench.
Place the hub in the center of the rim, and begin the
lacing with new spokes.
Adjusllhe hub position so the distance from the hub left
end surface 10
the side of the rim is 28.0 ±
1.0 mm (1 .10
± 0.04 in) as shown.
•
RIM
28.0 ± 1.0 mm
(1 .10±0.04in)
LEFT WHEEL HUB
Tighten the spokes in two or three progressive steps
liiii]]~r;~;;'~===~;C~l
(page
4-42).
I
Inslallths rim lock, setting rubber, tube and lire.
Tighten the rim lock (page 4-42).
Pack each wheel bearing cavity with grease.
~~~~~~~~~i~====~~~l
Drive a new left wheel bearing in the wheel hub until it is ,
fully seated using special tools,
• Instatl the wheel bearing with the sealed side toward
the outside.
TOOLS:
Driver
AHa chment, 37 x 40 mm
Pilot, 20 mm
07749-0010000
07746-0010200
07746-0040500
Install the distance collar into place, then drive a new
right wheel bearing using the same special tools.
~~~:~~~~~~~~~5f~~~~
Pack the lips of a new right dust seal with grease, and
install it to the wheel hub.