Hitachi Compute Blade 2000 User Manual page 1315

(5) How to set LPAR manager hang-up detection
Display the Options screen.
Position the cursor on LP ErrorWatching of System Control and press Enter to
display a subscreen. Move the cursor with arrow keys ([↑] or [↓]) to select 'Yes' or
'No' and press Enter.
(6) How to change the power capping function
LPAR manager firmware version 58-7X/78-7X or later
Make sure deactivate all LPARs before changing the power capping settings.
Display the LP Options screen.
Place the cursor on PhyCPU C-State (>= C3) and press Enter to display a
subscreen. On the subscreen, select Enable or Disable by moving the cursor with
arrow keys ([↑] or [↓]) and press Enter.
When all three conditions described below are met, the OS
system time lag might get larger. If so, disable the power
saving function.
With LPAR manager firmware version 58-12 or

later/78-12 or later, which the power saving function is
added to: supporting C6 state.
With Windows Server 2008 or Windows Server 2008 R2

or later as a guest OS.
Operating an application, such as Media Player, which

uses the multimedia timer.
(7) How to change the USB Auto Allocation to LPAR
LPAR manager firmware version 59-0X/79-0X or later
Place the cursor on USB Auto Allocation to LPAR, and press Enter to display a
subscreen. Select Enable or Disable on the subscreen and press Enter.
See the PCI Device Assignment screen for setting details.
(8) How to change Save Changed Config Format
LPAR manager firmware version 59-0X/79-0X or later
Save Changed Config Format automatically saves a changed configuration format
change at LPAR manager boot and unsaved configuration at LPAR manager halt.
This is not a periodical automatic save function.
(a) Saving configuration at LPAR manager boot
The following table describes behaviors depending on the setting when a
configuration format is changed at LPAR manager boot.
Save Changed Config Format
#
Disable
(1) Sends an alert reporting a change in configuration formats when
LPAR manager initialization is complete.
(2) Shows the following message to
prevent operation until
configuration is saved.
"Because the Configuration
Enable
Saves configuration
automatically.
1264
Version
supported
59-0X/79-0X or
later
Not supported