Hitachi Compute Blade 2000 User Manual page 1614

2. Specifications of SNMP Trap Function
Item
Means of notification
Maximum number of SNMP managers that can be
notified simultaneously
Event of notification
Content of Binding of the first variable
messaging
Binding of the second variable
Binding of the third variable
Binding of the fourth variable
Binding of the fifth variable
Binding of the sixth variable
Binding of the first variable
Binding of the second variable
Note: This SNMP trap function does not support the SNMP standard trap.
3. Specifications of SNMPv3
Item
Authentication: Hush method
Encryption method
(2) Prerequisites
Prerequisites for using the SNMP function are listed in the table below.
No.
1 The SNMP manager receiving SNMP traps must be compatible with SNMPv1/v2c/v3.
2 The environment must enable communications between the management module
and the management server where the SNMP manager operates.
SNMP
(SNMPv2Trap/SNMPv3Trap)
4
When the system event log (SEL)
of a management module fault is
issued.
Time when the alert was sent.
Chassis ID
Alert level
Alert message
Location where the alert occurred
Alert ID
See SVP (Service Processor Log)
Message in Chapter 6.
ID: 14Ex and 17Ex are out of target
for SNMP trap.
Time when the alert was sent.
Chassis ID
MD5/SHA-1
DES/AES128
Prerequisites
1563
Description
Description