Hitachi Compute Blade 2000 User Manual page 1583

To avoid misconnection with iSCSI for Personality, set

the following values to iSCSI on the standby partition.
Item
iSCSI Initiator IP Address
iSCSI Initiator Subnetmask
To take over NIC settings for Emulex 10 Gb CNA/LAN

mezzanine card or for onboard CNA board with N+M
cold standby, use the configurations of firmware and
driver versions shown in the following table.
CNA firmware
on Active server blade
4.1.334.2801
4.2.433.604
4.1.334.2801
4.2.433.604
Configuration with LAN driver 4.2.390.6 or 4.2.456.0 and CNA firmware
4.1.334.2801 is not supported.
To take over settings Emulex 10 Gb CNA (FCoE for

Personality) with N+M cold standby, the following
conditions need to be satisfied.
Item
Server blade
Management module firmware
To take over settings for Emulex 16 Gb 2-port fibre

channel adapter, Hitachi 16 Gb 1-port fibre channel
adapter, or Hitachi 16 Gb 2-port fibre channel adapter,
the following conditions need to be satisfied.
Item
Server blade
Management module firmware
Setting value
0.0.0.0
0.0.0.0
CNA firmware
on Standby server
blade
4.1.334.2801
4.1.334.2801
4.2.433.604
4.2.433.604
Standard server blade: X55S3
BMC firmware: 05-54 or later, or 07-01 or later
EFI firmware: 09-56/10-56 or later
High-performance server balde: X57A2
BMC firmware: 04-75 or later
EFI firmware: 07-54/08-54 or later
A0360 or later
High-performance server balde: X57A2
BMC firmware: 08-08 or later
EFI firmware: 07-65/08-65 or later
A0375 or later
1532
LAN driver
Windows Linux
4.1.334.25 4.1.334.18
4.1.334.25 4.1.334.18
4.1.334.25 4.1.334.18
4.2.390.6 4.2.456.0
Condition
Condition