Hitachi Compute Blade 2000 User Manual page 1260

The following table describes the list of VLAN ID assignment and Promiscuous
Mode settings.
# Title
(1) Segment: Displays the network segment identifier to show the list.
(2) LPAR# Displays the LPAR number to set the network identifier
shown in (1) from smaller to larger numbers.
(3) VNIC# Displays the virtual NIC number corresponding to the
LPAR shown in (2) from smaller to larger numbers.
(4) Prm Displays the promiscuous mode defined in the virtual
NIC shown in (3).
(5) Mode Displays the VLAN mode defined in the virtual NIC
shown in (3).
(6) VLAN ID Displays VLAN IDs defined in the virtual NIC shown in
(3) from smaller to larger numbers.
(7) TXRATE LPAR manager firmware version 59-7X/79-7X or later
ASSIGN For VF NIC:
Displays the total of transmission bandwidth limitation
assigned to the LPAR.
(8) ACT LPAR manager firmware version 59-7X/79-7X or later
For VF NIC:
Displays the total of transmission bandwidth limitation
used by the activated LPAR.
(9) TXRATE LPAR manager firmware version 59-7X/79-7X or later
For VF NIC:
Displays transmission bandwidth limitation for the
LPAR.
(10) ACT LPAR manager firmware version 59-7X/79-7X or later
For VF NIC:
Displays the LPAR status.
Y (Activate): Powered on
N (Deactivate): Powered off
Note: If the VLAN ID is not defined in the network segment identifier specified
by the cursor and F2:Disp VLAN ID Map is pressed, a message
'VLAN ID is not set.' is displayed.
Description
1209