Hitachi Compute Blade 2000 User Manual page 1587

(This setting applies to FC switches, SAN, and LUN Manager. For details,
see the documentation for the product concerned.)
(4) Server blade setup
 Partitions in Basic mode
Set up the server blade so that the active partition can be booted from the
SAN.
Fibre-channel board setting

Enable the BIOS for the Fibre-channel board, and enable the boot

priorities.
Select the LU to be booted.

For details about the procedure, see your Fibre-channel board

documentation.
CNA (iSCSI) setting

Set iSCSI settings including iSCSI Traget.

For further details, see the 10Gb Converged Network Production

Instruction Manual.
CNA (FCoE) setting

Set FCoE settings including enabling Boot Bios.

For further details, see the 10Gb Converged Network Production

Instruction Manual.
EFI setup (Xeon Server Blade)

Set the booting priority and enable the active partition to be

booted from the SAN.
For details about the procedure, see "Standard Server Blade

Setup Menu (X55A1/X55A2 Models)" in Chapter 5".
With a standard server blade, executing the Smart Configure changes the SAN boot
priority to the lowest automatically.
 Partitions in LP mode
Set up the server blade so that the LPAR configured in LPAR manager on
the active partition can be booted from the SAN.
EFI setup (Xeon Server Blade)

Confirm that the EFI settings are required for LPAR manager boot.

For details about EFI setup, see "Chapter 12: Logical partitioning

manager".
Auto Activate or Pre-State Auto Activate setting

NOTICE
1536