Hitachi Compute Blade 2000 User Manual page 1215

# Title Official Name
(13) MN Memory Node
(14) ID Idle Detection
(15) AA Auto Activation
Order
(16) AC Auto Clear
Description
LPAR manager firmware version 59-2X/79-2X or
later
<NUMA: disabled>
Displays the memory node assigned to the LPAR.
Memory node cannot be set.
・ Deactivate
A: Node will be automatically selected when the
LPAR is activated. Blank memories are
assigned in ascending order.
・ Activate
A: Node is automatically selected. Blank
memories are assigned in ascending order.
<NUMA: enabled>
Sets memory node to be assigned to the LPAR.
・ Deactivate
A: Node will be automatically selected. Blank
memories are assigned in ascending order.
0 to the maximum node number: Blank
memories of the node will be assigned
automatically in ascending order when the
LPAR is activated are assigned. Memories of
nodes other than those not set are not assigned.
・ Activate
0 to the maximum node number: Only nodes
displayed are assigned.
M: Multiple nodes are assigned.
The following table shows displayed memory items.
NUMA
Deactivate
setting
Disabled A
Enabled A or 0 to the
max #
Enables/disables the function that detects the idle
state of the logical processors.
Y: Enables Idle Detection.
N: Disables Idle Detection.
Set Y (default value) to an LPAR in dedicated mode.
Sets the automatic activation of a LPAR when LPAR
manager boots.
*‫ ׃‬Auto Activate is not set.
1-99‫ ׃‬Enables Auto Activate. The number
represents the order in which the LPARs are
activated. Small number is given priority.
Enables/disables the function that automatically
clears the logical SEL.
Y: Enables Auto Clear.
N: Disables Auto Clear.
1164
Initial Value
(When LPAR
is added)
Activate
A
0 to the max #
or M
Y
*
N