Hitachi Compute Blade 2000 User Manual page 1272

# Title Official Name
(6) BSM1~4 BSM1~4
Alert Port Alert ports
(7) Management Management
Path path
(8) VNIC System Virtual NIC
No system number
(9) Alert Language Alert Language
Mode
(10) Virtual Console Virtual COM
Port console TCP
port
(11) LPAR manager LPAR manager
Operating Operating Mode
Mode
(12) LP CLI1-8 IP LP CLI1-8 IP
Address Address
(13) Function Key Function key
Description
Sets the BSM alert port
When LPAR manager is started, the System
Manager 1~4 Alert Ports, which are set to the
management module, are applied as initial
values. (Recommended setting)
Displays NIC used for the management path.
default: uses onboard NIC for the management
path.
Sets a unique value to each LPAR manager
system including Compute Blade 1000, Compute
Blade 2000, and Compute Blade 320.
This value is used as part of the Virtual NIC's
MAC address.
Without setting this number, you cannot go to
another screen.
Sets the language used in the alert messages.
When LPAR manager is started, the Language
Mode that is set to the management module will
be applied as the initial value. (Recommended
setting)
Japanese: Displays the alert message in
Japanese.
English: Displays the alert message in English.
Set the TCP port to connect the LPAR guest
console via telnet.
Can set only a TCP port that is connect to VC1.
One is added to the TCP number of VC2 and
consecutive TCPs as one is added to the number
of VC.
When LPAR manager is booted, the TCP ports
(serial numbers starting from 20801) that LPAR
manager obtains are reflected by default: this
setting is recommended.
LPAR manager firmware version 58-71/78-71 or
later
Set LPAR manager operating modes.
Standard: LPAR manager standard mode
Expansion: LPAR manager expansion mode
When the configuration of the previous version
exists, the mode is Standard.
- Standard server blade X55R4 model supports
only Expansion
LPAR manager firmware version 58-6X/78-6X or
later:
Sets LP CLI IP Address.
Sets the IP address of a server blade where
commands such as PFM, ITRM, and HvmSh
operate.
Displays the function keys that can be used in this
screen.
F10: Used when changes are reflected in the
LPAR manager system.
1221
Initial Value
-
default:
0
-
20801
Expansion
0.0.0.0
-