Hitachi Compute Blade 2000 User Manual page 1311

# Title Official Name
(3) Shutdown Shutdown State Displays the LP system shutdown status.
State
(4) LP LPAR manager
ErrorWatching hang-up
detection
(5) PhyCPU Power capping
C-State (>=
C3)
(6) USB auto USB auto
Allocation to Allocation to
LPAR LPAR
(7) Save Changed Save Changed
Config Format Config Format
(8) Activation Activation
confirmation
(9) Deactivation Deactivation and
and reactivation
Reactivation confirmation
(10) Screen Screen switching
Switching character
Character
Description
Ready: The LPAR manager system is running.
InProgress: The LPAR manager system is shutting
down.
When the LPAR manager system is shut down
using the power control schedule of
ServerConductor / Blade Server Manager, the
shutdown state becomes InProgress when the
shutdown time arrives. In this case, it is possible to
cancel the shutdown then.
Sets whether or not to detect the hang-up of LPAR
manager itself.
Yes: Detects an LPAR manager hang-up. When
detects it, automatically collects LPAR manager
dump and restarts LPAR manager.
No: Does not detect an LPAR manager hang-up.
LPAR manager firmware version 58-7X/78-7X or
later
Sets whether to enable or disable the power
capping.
Enable: Enables the power capping function.
Disable: Disables the power capping function.
LPAR manager firmware version 59-0X/79-0X or
later
Enables or Disables USB Auto Allocation.
Enable: USB is automatically attached to an LPAR
when the LPAR is activated.
Disable: USB is automatically attached to only the
LPAR specified.
LPAR manager firmware version 59-0X/79-0X or
later
Sets whether or not to save a format changed at
LPAR manager boot or information that is not yet
saved at LPAR manager halt.
Enable: Saves the changed configuration format.
Disable: Not save the changed configuration
format.
Specifies the display of a confirmation prompt
subscreen when activating an LPAR from the
LPAR manager screen.
Yes: Displays the confirmation prompt subscreen.
No: Does not display the confirmation prompt
screen.
Specifies the display of a confirmation prompt
subscreen when deactivating or reactivating an
LPAR from the LPAR manager screen.
Yes: Displays the confirmation prompt subscreen.
No: Does not display the confirmation prompt
screen.
Sets the character used to switch from a guest
screen to the LPAR manager screen. "l" (the lower
case "L") is set as the default. You can use all
lower case letters except for b, h, i, j, m, g, s and z.
1260
Initial
Value
-
Yes
Enable
Enable
Disable
Yes
Yes
l