Siemens Sinumerik 840D sl Diagnostic Manual page 92

Overview of Alarms
NCK alarms
Remedy: Please inform the authorized personnel/service department. Correct the machine data:
MD37100 $MA_GANTRY_AXIS_TYPE
0: No gantry axis 1: Master axis grouping 1 11: Slave axis grouping 1 2: Master axis grouping 2 12:
Slave axis grouping 2 3: Master axis grouping 3 13: Slave axis grouping 3
Program Con- Switch control OFF - ON.
tinuation:
10651 [Channel %1: ] Gantry configuration error. Error code %2
Parameters: %1 = Channel number
%2 = Reason
Definitions: The gantry configuration set in the machine data is erroneous. Gantry unit and reason for objection
can be found in the transfer parameter.
The transfer parameter is made up as follows.
- %2 = error designation + gantry unit (XX).
- %2 = 10XX => no master axis declared
- %2 = 20XX => no slave axis declared
- %2 = 30XX => different contents in MD30550 $MA_AXCONF_ASSIGN_MASTER_CHAN slave axis
and master axis
- %2 = 40XX => different channel or NCU assignment of the gantry axes
- %2 = 50XX => no slave axis declared in this channel
- 2% = 60XX => different channel assignment of the master axis
- %2 = 10000 => error: slave axis is geometry axis
- %2 = 11000 => error: competing positioning axis as slave axis
- %2 = 12000 => error: compile cycle axis as slave axis
- %2 = 13000 => error: gantry axis is spindle
- %2 = 14000 => error: gantry axis is Hirth geared
e.g. error code 1001 = no master axis declared, gantry unit 1.
Reaction: NC not ready.
Mode group not ready, also effective for single axes
NC Start disable in this channel.
Interface signals are set.
Alarm display.
NC Stop on alarm.
Remedy: Please inform the authorized personnel/service department. Correct the machine data:
MD37100 $MA_GANTRY_AXIS_TYPE
0: No gantry axis
1: Master axis grouping 1
11: Slave axis grouping 1
2: Master axis grouping 2
12: Slave axis grouping 2
3: Master axis grouping 3
13: Slave axis grouping 3
Program Con- Switch control OFF - ON.
tinuation:
10652 [Channel %1: ] Axis %2 gantry warning threshold exceeded
Parameters: %1 = Channel number
%2 = Axis
Definitions: The gantry following axis has exceeded the warning limit specified in MD37110
$MA_GANTRY_POS_TOL_WARNING.
Reaction: Alarm display.
Remedy: Please inform the authorized personnel/service department.
1. Check axis (uneven mechanical movement?)
2. MD not set correctly (MD37110 $MA_GANTRY_POS_TOL_WARNING). Changes to this MD take
effect after a RESET.
Program Con- Alarm display showing cause of alarm disappears. No further operator action necessary.
tinuation:
2-92
SINUMERIK 840D sl, 840Di sl, SINAMICS, Diagnostics Manual (DAsl), 03/2009
© Siemens AG, 2009. All Rights Reserved
03/2009