Siemens Sinumerik 840D sl Diagnostic Manual page 519

03/2009
61608 [Channel %1: ] Block %2: Incorrect tool point direction programmed
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Alarm triggered by following cycles: CYCLE94, CYCLE96.
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: A cutting edge position 1...4, matching the undercut form, must be programmed.
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
61609 [Channel %1: ] Block %2: Shape incorrectly defined
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Alarm triggered by following cycles: CYCLE94, CYCLE96, LONGHOLE, POCKET3, SLOT1.
Remedy: Check parameter for the undercut form or groove form or pocket.
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
61610 [Channel %1: ] Block %2: No infeed depth programmed
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Alarm triggered by following cycles: CYCLE76, CYCLE77, CYCLE96.
Remedy: Check parameter MID.
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
61611 [Channel %1: ] Block %2: No point of intersection found
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: No intersection could be calculated with the contour. Alarm triggered by following cycle: CYCLE95.
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: Check contour programming or modify infeed depth.
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
61612 [Channel %1: ] Block %2: Thread finishing not possible
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Alarm triggered by following cycles: CYCLE97, CYCLE98.
Remedy: Check the conditions for thread finishing.
61613 [Channel %1: ] Block %2: Undercut position incorrectly defined
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Alarm triggered by following cycles: CYCLE94, CYCLE96.
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: Check value in parameter _VARI.
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
© Siemens AG, 2009. All Rights Reserved
SINUMERIK 840D sl, 840Di sl, SINAMICS, Diagnostics Manual (DAsl), 03/2009
Overview of Alarms
NCK alarms
2-519