Overview of Alarms
NCK alarms
Remedy:
- Check programming of the pocket contour
Program Con-
Clear alarm with the RESET key. Restart part program
tinuation:
61910
[Channel %1: ] Block %2: Error in the blank contour %4
Parameters:
%1 = Channel number
%2 = Block number, label
Definitions:
Alarm triggered by following cycles: CYCLE63
Reaction:
Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy:
- Check programming of the blank contour
Program Con-
Clear alarm with the RESET key. Restart part program
tinuation:
61911
[Channel %1: ] Block %2: Error in island contour %4
Parameters:
%1 = Channel number
%2 = Block number, label
Definitions:
Alarm triggered by following cycles: CYCLE63
Reaction:
Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy:
- Check programming of the island contour
Program Con-
Clear alarm with the RESET key. Restart part program
tinuation:
61912
[Channel %1: ] Block %2: Error in spigot contour %4
Parameters:
%1 = Channel number
%2 = Block number, label
Definitions:
Alarm triggered by following cycles: CYCLE63
Reaction:
Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy:
- Check programming of the spigot contour
Program Con-
Clear alarm with the RESET key. Restart part program
tinuation:
61913
[Channel %1: ] Block %2: Error in contour %4
Parameters:
%1 = Channel number
%2 = Block number, label
Definitions:
Alarm triggered by following cycles: CYCLE64
Reaction:
Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy:
- Check programming of the contour
Program Con-
Clear alarm with the RESET key. Restart part program
tinuation:
61914
[Channel %1: ] Block %2: Too many contours specified
Parameters:
%1 = Channel number
%2 = Block number, label
Definitions:
Alarm triggered by following cycles: CYCLE63, CYCLE64
Reaction:
Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
2-532
SINUMERIK 840D sl, 840Di sl, SINAMICS, Diagnostics Manual (DAsl), 03/2009
© Siemens AG, 2009. All Rights Reserved
03/2009