Siemens Sinumerik 840D sl Diagnostic Manual page 603

03/2009
112057 Programmed helix violates contour
Definitions: The starting point for helical insertion was so selected, that the helix violates the programmed contour.
The program can be started.
This alarm is only a warning.
Reaction: Alarm display.
Remedy: Select another starting point; use a smaller helix radius.
Program Con- Internal
tinuation:
112099 System error contour pocket %1
Definitions: While the contour pocket was being calculated, an error occurred. The contour pocket cannot be cal-
culated.
The program cannot be started.
Reaction: Alarm display.
Remedy: Please contact the hotline of Siemens AG, A&D MC and provide with the error message.
Program Con- Internal
tinuation:
112100 Error on renumbering.%nInitial state restored.
Definitions: The softkey "Renumber" was pressed in the program editor. This caused an error during serial num-
bering that damaged the program in the memory, making it necessary to reload the initial program into
the memory.
The program was not renumbered.
Reaction: Alarm display.
Remedy: Make room in the memory, e.g. by deleting an old program. Select "Renumber" again.
Program Con- Internal
tinuation:
112200 The contour is a step in the current program%nsequence. Machining not
enabled
Definitions: The contour is an element from a loaded program and cannot be deleted or renamed.
Reaction: Alarm display.
Remedy: Remove the contour from the loaded program.
Program Con- Internal
tinuation:
112201 Contour is step in current automatic chain%nMachining not possible.
Definitions: The contour is an element of a program loaded under "Machine auto" and cannot be deleted or
renamed.
After the program has been started, the integrated contours cannot be changed under "Program"
while the program is running.
Reaction: Alarm display.
Remedy: Stop the program and load it under "Program". Remove the contour from the program.
Program Con- Internal
tinuation:
112210 Tool axis cannot be changed. Not enough NC-%nmemory.
Definitions: If the tool axis is reselected, the NC program has to be generated again. Hereby the old NC program
is saved first.
Then the new program is generated. Here, the NC memory is insufficient to save the new program.
The reselection of the tool axis was not carried out.
Reaction: Alarm display.
Remedy: Free memory space must be created on the NC, and it must be enough for the program to be pro-
cessed (e.g. by deleting programs that are no longer required).
Program Con- Internal
tinuation:
© Siemens AG 2009 All Rights Reserved
SINUMERIK 840D sl, 840Di sl, SINAMICS, Diagnostics Manual (DAsl), 03/2009
Overview of Alarms
HMI-Alarms
2-603