Siemens Sinumerik 840D sl Diagnostic Manual page 254

Overview of Alarms
NCK alarms
16673 [Channel %1: ] Block %2 leading axis/spindle %3 maximum number of
CP master values (%4) exceeded
Parameters: %1 = Channel number
%2 = Block number, label
%3 = Axis name, spindle number
%4 = Max. number of CP master values
Definitions: An attempt was made to activate more master values of generic couplings than are configured in
MD18452 $MN_MM_NUM_CP_MODUL_LEAD.
Reaction: NC Start disable in this channel.
Interface signals are set.
Alarm display.
NC Stop on alarm.
Remedy: Reduce the number of defined or active master values, or increase the total number of master values
configured in MD18452 $MN_MM_NUM_CP_MODUL_LEAD.
If necessary, buy another option stage of the generic coupling.
Program Con- Clear alarm with the RESET key in all channels. Restart part program.
tinuation:
16675 Channel %1 block %2 following axis/spindle %3 coupling module already
defined in channel %4
Parameters: %1 = Channel number
%2 = Block number, label
%3 = Axis/spindle
%4 = Channel number
Definitions: An attempt was made to define or activate a CP coupling, although a coupling had already been
defined or activated on this following axis/spindle in another channel.
Reaction: NC Start disable in this channel.
Interface signals are set.
Alarm display.
NC Stop on alarm.
Remedy: Change the part program: A CP coupling module must not be simultaneously defined in multiple chan-
nels for the same following axis/spindle.
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
16678 [Channel %1: ] Block %2 following axis/spindle %3 status %4
impermissible traversing instruction
Parameters: %1 = Channel number
%2 = Block number, label
%3 = Axis name, spindle number
%4 = Status
Definitions: An addtional traversing in the following axis/spindle is not permitted in the current status
of the generic coupling.
Example: CPOF=X G0 X100 is not permitted.
Reaction: Correction block is reorganized.
Interface signals are set.
Alarm display.
Remedy: Modify part program.
A motion in the following axis/spindle can be programmed with CPFPOS, CPON or CPOF
Program Con- Clear alarm with NC START or RESET key and continue the program.
tinuation:
16680 [Channel %1: ] Block %2 following axis/spindle %4 instruction %3
programmed repeatedly
Parameters: %1 = Channel number
%2 = Block number, label
%3 = CP instruction
%4 = Axis name, spindle number
2-254
SINUMERIK 840D sl, 840Di sl, SINAMICS, Diagnostics Manual (DAsl), 03/2009
© Siemens AG, 2009. All Rights Reserved
03/2009