Siemens Sinumerik 840D sl Diagnostic Manual page 465

03/2009
61124 [Channel %1: ] Block %2: Infeed width is not programmed
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Alarm triggered by following cycle: CYCLE71.
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: With active simulation without tool, a value for the infeed width _MIDA must always be programmed.
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
61125 [Channel %1: ] Block %2: Technology selection parameter incorrectly
defined
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Alarm triggered by following cycles: CYCLE84, CYCLE840.
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: Check technology selection parameter (_TECHNO).
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
61126 [Channel %1: ] Block %2: Thread length too short
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Alarm triggered by following cycle: CYCLE840.
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: Program lower spindle speed or raise reference point (reference plane).
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
61127 [Channel %1: ] Block %2: Wrong definition of tapping axis
transformation ratio (machine data)
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Alarm triggered by following cycles: CYCLE84, CYCLE840.
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: Check machine data 31050 and 31060 in the appropriate gear stage of the drilling axis.
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
61128 [Channel %1: ] Block %2: Insertion angle = 0 for insertion with oscillation
or helix
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Alarm triggered by following cycle: SLOT1.
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
© Siemens AG, 2009. All Rights Reserved
SINUMERIK 840D sl, 840Di sl, SINAMICS, Diagnostics Manual (DAsl), 03/2009
Overview of Alarms
NCK alarms
2-465