Siemens Sinumerik 840D sl Diagnostic Manual page 486

Overview of Alarms
NCK alarms
61255 [Channel %1: ] Block %2: Error during cut-off: Tool broken?
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Cut-off could not be completed. A tool breakage might have occurred.
Alarm triggered by following cycles: F_PARTOF, F_SUB_SP.
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: Check the tool.
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
61256 [Channel %1: ] Block %2: Mirroring not allowed at program start.
Deselect work offset!
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Mirroring impermissible at program start.
Alarm triggered by following cycle: F_HEAD.
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: Deselect work offset.
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
61257 [Channel %1: ] Block %2: incomplete installation of counterspindle
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Start-up of the counterspindle is incomplete.
Alarm triggered by following cycle: F_SUB_SP.
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: Check display machine data 9803, 9851, 9852, 9853 and 9854.
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
61258 [Channel %1: ] Block %2: set parameters for counterspindle chuck in the
spindle image
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The parameters for the counterspindle chuck have not been set in the spindle view.
Alarm triggered by following cycle: F_SUB_SP.
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: Specify parameters "ZL1", "ZL2" and "ZL3" in mask "Tools work offset" > "Spindles".
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
61259 [Channel %1: ] Block %2: program contains new machining steps from
ShopMill %4
Parameters: %1 = Channel number
%2 = Block number, label
%4 = ShopMill version
2-486
SINUMERIK 840D sl, 840Di sl, SINAMICS, Diagnostics Manual (DAsl), 03/2009
© Siemens AG, 2009. All Rights Reserved
03/2009