Siemens Sinumerik 840D sl Diagnostic Manual page 249

03/2009
Definitions: The spindle number programmed for PUTFTOC or PUTFTOCF is beyond the permitted range for the
spindle numbers.
Reaction: Correction block is reorganized.
Interface signals are set.
Alarm display.
Remedy: Modify part program. Is the programmed spindle number available?
Program Con- Clear alarm with NC START or RESET key and continue the program.
tinuation:
16200 [Channel %1: ] Block %2 spline and polynominal interpolation not
available
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The spline and polynomial interpolation are options that are not contained in the basic version of the
control.
Reaction: Correction block is reorganized.
Interface signals are set.
Alarm display.
Remedy: Do not program spline and polynomial interpolation, or retrofit the necessary option.
Program Con- Clear alarm with NC START or RESET key and continue the program.
tinuation:
16300 [Channel %1: ] Block %2 denominator polynominal with zero places
within parameter range not allowed
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The programmed denominator polynomial (with PL [ ] = ... , i.e. without specification of geometry axis)
has a zero place within the defined parameter range (PL = ...). This means that the quotient of the
numerator polynomial and the denominator polynomial is infinite or indeterminate.
Reaction: Correction block is reorganized.
Interface signals are set.
Alarm display.
Remedy: Modify the polynomial block so that there is no zero place within the polynomial length in the denom-
inator polynomial.
Program Con- Clear alarm with NC START or RESET key and continue the program.
tinuation:
16400 [Channel %1: ] Block %2 positioning axis %3 cannot participate in spline
Parameters: %1 = Channel number
%2 = Block number, label
%3 = Axis name, spindle number
Definitions: An axis assigned to a spline grouping (n) with SPLINEPATH (n, AX1, AX2, ...) has been programmed
as positioning axis with POS or POSA.
Reaction: Correction block is reorganized.
Interface signals are set.
Alarm display.
Remedy: Do not assign the positioning axis to the spline grouping.
Program Con- Clear alarm with NC START or RESET key and continue the program.
tinuation:
16410 [Channel %1: ] Block %2 axis %3 is not a geometry axis
Parameters: %1 = Channel number
%2 = Block number, label
%3 = Axis name, spindle number
© Siemens AG, 2009. All Rights Reserved
SINUMERIK 840D sl, 840Di sl, SINAMICS, Diagnostics Manual (DAsl), 03/2009
Overview of Alarms
NCK alarms
2-249