Siemens Sinumerik 840D sl Diagnostic Manual page 621

03/2009
Remedy: Switch off/on drive system including all DRIVE-CLiQ components.
Program Con- Internal
tinuation:
129900 Data of passive drives are not backed up!
Definitions: This indicates that passive drives are not backed up as well when an upgrade is made.
Reaction: Alarm display.
Remedy: If the drive shall be backed up as well, it must be enabled. If the note shall not be displayed again, set
the drive to "0" in machine data 30240 ENC_TYPE and 30130 CTRLOUT_TYPE.
Program Con- Internal
tinuation:
129901 Time determination is being initialized. Please wait...
Definitions: This indicates that the time determination is being initialized and that the operator shall not yet press
NC Start or execute other operator actions.
Reaction: Alarm display.
Remedy: Not necessary. After completion of the initialization, the dialog box will be faded out again automati-
cally.
Program Con- Internal
tinuation:
129902 Recorded data are being processed. Please wait...
Definitions: This indicates that data recorded by time determination are currently processed and that the operator
shall not yet press NC Start or execute other operating actions.
Reaction: Alarm display.
Remedy: Not necessary. After completion of the initialization, the dialog box will be faded out again automati-
cally.
Program Con- Internal
tinuation:
129903 Time determination is active.
Definitions: This indicates that time determination is enabled and that the user can press NC Start.
Reaction: Alarm display.
Remedy: Not necessary. As soon as all channels viewed for time determination are in Reset again, this mes-
sage will be cancelled automatically.
Program Con- Internal
tinuation:
129904 %1: Current NCK Version %2 is too low for time measurement. Version
500000 or higher will be required.
Parameters: %1 = Name of the NCU according to NETNAMES.INI
%2 = Current NCU version
Definitions: The version of the specified NCU is too old (< 500000).
Remedy: Upgrade or replace the relevant NCU for the required software version in order to use the time deter-
mination.
129905 %1: Unable to determine the NCK version for time measurement.
Parameters: %1 = Name of the NCU according to NETNAMES.INI
Definitions: The version of the specified NCU could not be determined.
Remedy: Connect to the NCU and restart the PCU if required.
129906 %1: Unable to determine the number of channels.
Parameters: %1 = Name of the NCU according to NETNAMES.INI
Definitions: The number of channels of the specified NCU could not be determined.
Remedy: Connect to the NCU and restart the PCU if required.
129907 %1:The max. number of channels could not be determined.
Parameters: %1 = Name of the NCU according to NETNAMES.INI
Definitions: The maximum number of channels of the specified NCU could not be determined.
© Siemens AG 2009 All Rights Reserved
SINUMERIK 840D sl, 840Di sl, SINAMICS, Diagnostics Manual (DAsl), 03/2009
Overview of Alarms
HMI-Alarms
2-621