Siemens Sinumerik 840D sl Diagnostic Manual page 439

03/2009
Remedy: Check the F parameterization in MD $MN_PROFISAFE_IN/OUT_ADDRESS.
Check the F configuration in the S7 PROFIBUS configuration.
Check the parameterized PROFIsafe master address in MD
$MN_PROFISAFE_MASTER_ADDRESS and in the S7 PROFIBUS configuration.
Program Con- Switch control OFF - ON.
tinuation:
27221 PROFIsafe: NCK F module MD %1[%2] unknown
Parameters: %1 = MD name
%2 = MD array index
Definitions: The F module parameterized in the specified machine data is unknown under this PROFIsafe address
in the S7 PROFIBUS configuration.
Reaction: Mode group not ready.
Channel not ready.
NC Start disable in this channel.
Interface signals are set.
Alarm display.
NC Stop on alarm.
Remedy: Check the PROFIsafe addresses in the NCK MD and S7 PROFIBUS configuration.
Program Con- Switch control OFF - ON.
tinuation:
27222 PROFIsafe: S7 F module PROFIsafe address %1 unknown
Parameters: %1 = PROFIsafe address
Definitions: The F module with the specified PROFIsafe address has not been parameterized as an F module in
the NCK MD.
Reaction: Mode group not ready.
Channel not ready.
NC Start disable in this channel.
Interface signals are set.
Alarm display.
NC Stop on alarm.
Remedy: Check the S7 PROFIBUS configuration. Enter the module in the NCK MD.
Program Con- Switch control OFF - ON.
tinuation:
27223 PROFIsafe: NCK F module MD %1[%2] is not a %3 module
Parameters: %1 = MD name
%2 = MD array index
%3 = Module type
Definitions: The F module parameterized in the specified NCK MD has not been entered as input/output module
in the S7 PROFIBUS configuration.
- %3 = INPUT: NCK F parameterization expects INPUT module
- %3 = OUTPUT: NCK F parameterization expects OUTPUT module
- %3 = IN/OUT: NCK F parameterization expects INPUT or OUTPUT module
Reaction: Mode group not ready.
Channel not ready.
NC Start disable in this channel.
Interface signals are set.
Alarm display.
NC Stop on alarm.
Remedy: Check the module in the S7 PROFIBUS configuration.
Program Con- Switch control OFF - ON.
tinuation:
27224 PROFIsafe: F module MD %1[%2] - MD %3[%4]: double assignment of
PROFIsafe address
Parameters: %1 = MD name 1
%2 = MD array index 1
%3 = MD name 2
%4 = MD array index 2
© Siemens AG, 2009. All Rights Reserved
SINUMERIK 840D sl, 840Di sl, SINAMICS, Diagnostics Manual (DAsl), 03/2009
Overview of Alarms
NCK alarms
2-439